Auto Toilet Flush Valve KEG-3500D Specification
|External Power Supply||Applicable water pressure||Applicable Water Temperature||Ambient Temperature||Feedwater caliber||Flushing water volume|
|AC:110v-240V,50Hz-60Hz||DC&AC combined||0.3-0.8Mpa||0.1-60℃||0.1-45℃||G1”||4-6L(10s based on water pressure of 0.3-0.6Mpa)|
How to install automatic toilet flush?
Touchless Toilet Flusher Troubleshooting
|Problem||Possible Reason||Suggested Solution|
|No water flow||Batteries run out||Replace batteries|
|Dirt on the sensor surface||Clean the sensor surface|
|The main water supply is shut off||Turn the main water supply on|
|Dirt on water filter net||Clean the water filter net|
|Water pressure is not applicable||Refer to the technical specification|
|Have a continuous water flow problem||Batteries run out||Replace batteries|
|Low water pressure||Refer to the technical specification|
People who are asking more:
How Does automatic toilet flusher Work?
Automatic toilet flusher uses infrared sensor technology that will flush automatically after leaving, the sensor detects and gives a pulse signal to the solenoid valve, when you leave, flush automatically. Microchip controls all the processes.
Do AUTO toilet FLUSH need electricity?
Auto toilet flushers need electricity for sure. Both the sensor and solenoid valve works need electricity power.
Normally three choices:
DC: 4xAA alkaline 6V batteries;
AC: use a transformer to transfer power from 220V/380V to 6V;
DC/AC：Both DC/AC models existed, firstly use AC power to work, if AC no power then DC start to work.
How long do batteries last in AUTOMATIC FLUSHer for toilets?
6V with 4xAA alkaline batteries shall last approximately 3000 times/month for 1.5 to 2 years.
how to manually flush a toilet?
Normally there is a manual button on top of the cistern. If the automatic flush and remote control functions fail, you can active the manual button.